Knurl / Stainless Steel Cabinet Pull

What this cabinet pull is

This is a single stainless steel pull or knob for cabinet doors and drawers. The surface has a knurled texture, so your fingers get a firm hold even when the door is heavy. The material is stainless steel, which suits kitchens and bathrooms where hardware sees daily use. Each piece is sold on its own, so you can order the exact count your project needs.

Sizes and shapes

Pick the size from the options list.

Check your existing holes before you order. If you are drilling new holes, mark the centers first and measure twice.

How to fit it

Each pull and knob fixes with two M4 screws driven from the back of the door or drawer front. The screws pass through the mounting holes and thread into the piece, so no hardware shows on the face. Two screw lengths are included: 1 in (25 mm) and 1-3/4 in (45 mm). Use the shorter screws for standard cabinet fronts and the longer ones for thicker panels. The hardware is not for doors thicker than 2 in (50 mm).

A few notes for fitting day:

• Check the spacing against your existing holes before ordering.
• For new installs, drill pilot holes at the marked centers.
• Tighten the screws by hand until the pull sits flush. Do not over tighten.
• Work one door at a time so you can compare spacing as you go.

Where it works

Use these on kitchen cabinet doors and drawers, bathroom vanities, built-in cupboards, and storage furniture. The stainless steel finish reads clean and modern, and the knurled grip suits both a slim bar pull on a wide drawer and a compact knob on a narrow door. Because each piece is sold as a single unit, you can mix sizes across a run of cabinets and keep the same look throughout.

Care

Wipe the hardware with a dry cloth. That is all it needs to stay clean. Avoid wet cloths and abrasive cleaners, which can dull the surface over time.