Brushed gold, knurled detail

Knurled bathroom hardware in brushed gold

$51.95 ~~$56.95~~

Brushed gold bathroom hardware in brass and stainless steel, accented with a short band of diamond knurling at the post and mounted on a round wall plate.

Expected delivery Sat, Nov 7 to Sat, Nov 14

Free shipping over $49
30-day returns

Shipping and returns

Free shipping over $49. Arrives in 9-16 days. Shipping times and costs per country

Not what you were looking for? Return it within 30 days of delivery. How returns work

Specifications

Material: Brass and 304 stainless steel
Finish: Brushed gold
Wall plate: 2 in (50 mm) round
Projection: 3-1/16 in (78 mm); double bar 4-5/8 in (118 mm)
Bar lengths: 11 in (280 mm) hand towel bar; 17-3/4 and 19-11/16 in (450 and 500 mm) towel bars
Mounting: Screws through the wall plate
Sold: Piece by piece
Not for: Grab bars or taking body weight

The pieces

Toilet paper holder: a 6-3/16 in (157 mm) arm with an open end, so a new roll slides straight on.
Hand towel bar: 11 in (280 mm) long, for the towel next to the sink.
Towel ring: an open rectangle, 7-7/8 x 5-7/8 in (200 x 150 mm), for a hand towel you grab without looking.
Towel bars: single bars of 17-3/4 in (450 mm) and 19-11/16 in (500 mm), and a 19-11/16 in (500 mm) double bar for two bath towels.

Every piece shares the same 2 in (50 mm) round wall plate, so any mix of them reads as one set.

The knurl

Each arm carries a short band of fine crosshatch knurling right at the post. It catches the light differently from the smooth brushed metal around it, a small detail you notice up close on pieces that otherwise stay quiet. On a wet morning it also gives your fingers something to find.

Sizes and spacing

The paper holder, hand towel bar and single towel bars stand 3-1/16 in (78 mm) off the wall, enough room for a folded towel without it pressing on the wall. The towel ring stands out 3-1/8 in (80 mm). The double bar sets its front bar 4-5/8 in (118 mm) out, so the two towels hang apart and dry faster.

Before you drill, hold the bar up and mark both ends with a level. On a narrow wall between a door and a vanity, the 17-3/4 in (450 mm) bar leaves more space around it.

Materials and finish

The pieces are made from brass and 304 stainless steel under a brushed gold finish. Brushed gold is a soft, warm color with a fine grain, and it is far more forgiving of water spots and fingerprints than polished brass. It sits well with white tile, warm wood vanities and black or brass faucets.

Fitting

Each piece fixes to the wall with screws through its round plate. Use wood screws where you hit a stud and rated anchors in drywall. On tile, tape the spot and drill with a tile bit at low speed. A towel bar that carries wet bath towels holds best with at least one end in a stud.

Care

Wipe with a soft damp cloth and dry it off. Mild soap is fine. Bleach, scouring pads and metal polish are not, because they wear through a brushed finish.

Questions

Is this a set, or sold piece by piece?

Piece by piece. Choose each one from the menu and add it to your bag. Every piece uses the same round wall plate and knurled band, so they match however many you buy.

Which towel bar length should I choose?

Measure the wall where the towel will hang and leave a few inches on each side. The 19-11/16 in (500 mm) bar takes a bath towel folded in thirds; the 17-3/4 in (450 mm) bar suits narrow walls and smaller towels.

Does brushed gold match brass faucets?

It is close to most brushed and satin brass faucets, and a little softer than polished brass. Faucet finishes vary by maker, so if you are matching exactly, hold the photos up beside your faucet in daylight.

Can I fit it to a tiled wall?

Yes. Put masking tape over the spot, drill through the tile with a carbide or diamond tile bit at low speed, then fit anchors that suit the wall behind the tile.

What if it doesn't suit the room?

Unused pieces can come back within 30 days of delivery. Keep the packaging until you have seen the finish in your own light.